03 · Test & Measurement
LIN RGB Test & Calibration
Volt, intensity and colour bins, checked against a golden reference.
Compares every RGB module side by side with a pre-calibrated golden module under the same LIN command, voltage and temperature, and calibrates over LIN where needed.
bins per LED — volt
plus key colours checked on CIE x
supply sweep (example
The result is a difference, not an absolute
Measuring colour absolutely needs lab-grade instruments that drift on a production line. Here the result is the difference from a known-good module under the same conditions, so sensor ageing, fixture drift and ambient light cancel out.
Calibrate or reject
Within tolerance → PASS. Out of tolerance but correctable → calibrate over LIN, then re-verify. Out and not correctable → REJECT. Every value is logged against the module serial.
Interactive
Colour bins on the CIE diagram
- Δx vs ref
- —
- Δy vs ref
- —
- Vf (R/G/B)
- —
- Iv @100 %
- —
How it works
- 01
Golden reference
A pre-calibrated
- 02
Same stimulus
Both receive the same LIN command, supply voltage and temperature.
- 03
Measure & compare
Current, Vf, intensity and colour of every LED are compared with the reference.
- 04
Calibrate over LIN
If out but correctable
- 05
Result + log
PASS / CAL / REJECT, with all values stored.
Specifications
- Volt bin
- Forward voltage Vf of R
- Intensity bin
- If → Iv; brightness linearity at 10 / 50 / 100 % PWM
- Colour bin
- CIE 1931 x
- Temperature
- 25 °C · 85 °C (to customer specification)
- Bus
- LIN 2.x master with LDF-based configuration
Final configuration is designed to your parts, cycle time and specifications.
Start a project
Let's scope your LIN RGB Test & Calibration.
Send us a sample, a drawing or just a description. An engineer, not a salesperson, will reply within one working day.
